Cherish ID Photo Holder

Cherish ID Photo Holder

Product Features

We are unveiling the ID photo holder that BIT BY BIT produced for the first time.

A design that allows you to put two ID photos on the left and right. Put your precious photo in the cute red heart-shaped frame and use the included ball chain to go out together.

You can use it cutely by inserting ID photos of idols, photos of your best friends, lovers, and pets.

Please check the description below for the size of the photo that can be stored.

content

1 BIT BY BIT ID Photo Holder

Size: Exterior 130 x 110mm, photo window 28 x 38mm
Internal photo storage Can store up to 36 x 46mm size

Material: PVC

Country of manufacture: South Korea

Notes on ordering

Depending on the monitor, the actual color may differ from the posted photo. Also, please note that due to the characteristics of the printed matter, the color of the same product may differ slightly depending on the lot.

There may be fine pressure marks and scratches on the side. This is an unavoidable phenomenon due to the characteristics of the material, and is not a defective product.

You can put ID photos up to 36 x 46 mm in size.

The surface of the photo is unprotected and a 28 x 38 mm area is visible from the front. Therefore, photos smaller than the above size may come off the holder. If you want to put a small photo, please take measures such as pasting it on a large piece of paper.

There may be a gap or size error of about 1-2mm.

Precautions for use

This product is for ages 14 and over. Keep out of reach of children.

Comes with a red ball chain. It will be delivered without the ball chain through the chain hole to prevent damage.

When stored in a low temperature environment or used for a long time, the surface may crack. Be sure to store and use the product in a warm place or at room temperature.

Please refrain from using it for anything other than its intended purpose.